Unable to install
Written by: sunny93
03/18/2016 12:58 pm
The foam I purchased was difficult to install. After removing the handle of the buggy another part of the handle needed separation for foam to slip on. This part was joined with rivets (not screws). Revets are not easy to remove and require special equipment. If I have known this I wouldn't have purchased the item.
Great handle cover, hard to replace
Written by: megera12
11/24/2015 01:05 pm
The handle cover/grip I ordered is fabulous on the stroller. It was extremely difficult to get on the handle, however. To replace, you need to find the two screws on each side of the handle bar (totaling 4 screws). After removing srews, a good tug will pull the handle bar out of the stroller. I cut the old foam grip off, and, as for the new one, I soaked it in hot soapy water, as was recommended online. Even then, it was super hard to get on. I finally found that twisting the foam and simultaneously pushing it up and around the handle bar did the trick. Just remember to twist, but still plan for some serious effort.