Fits perfectly but screws are useless
Written by: Vwsplitty
02/05/2018 07:09 am
This would be five stars but for the fact the screws they give you are too small. You have to drill out the pop rivets which is fine but the hole that is left (I didn’t over drill the hole) when the pop rivet comes out is too large for the screws. The only way I could think those screws would work is if you just removed the head of the pop rivet and screwed in to the remainder but this would not be very secure. I had some pop rivets so just use those but most people will not have these laying around.
if Phil & teds are reading this please put bigger self drillling screws in the pack.
Ease of use is unparalleled
Written by: Heather hamlin
06/12/2017 02:23 am
Only one thing I don't like about my Voyager is that when the car seat with proper adapter is on the bottom, my sons seat will not remain in the seated position. This means he has to ride on bottom and can't see anything (with him being 2 1/2, this creates issues). But, everything else is incredible. Easy to use, fold, adjust, pack, maneuverability, etc.
Great feature to have when it's not broken
Written by: Erin 31
04/29/2017 01:50 am
I bought this to replace the previous one that broke off. So far it's tight, hard to latch and unlatch but will loosen up. Hopefully it lasts longer than the first one, which lasted less than 2 years.
Screws where too small
Written by: Hashwe
12/04/2016 04:07 am
Great to be able to buy a replacement frame lock for the Navigator as getting it in and out of the car without was a complex maneuver if one wanted to keep fingers. However I had to buy new screws as the one provided were too loose and fell out of the hole left by the rivet. Also you really have to squash the folded frame for it to lock, so nothing can be left in the basket and you need to resquash the frame to open, this is rather too much effort when holding a baby.
So difficult to remove the old broken piece
Written by: trionamum
09/24/2016 02:26 am
This was an essential purchase. It was v difficult to remove the original piece which had broken. Had to use wider screws than those supplied to attach the new piece. 3 stars as it was essential for folding the buggie that I love. Lost 2 stars as it was a really tough job to fix the new lock.
Screws not suitable
Written by: ellemme
07/24/2016 04:13 am
The frame lock parts themselves are fine, but unfortunately the screws that were supplied are far too small for the holes in the frame of my v1 DOT. I have had to buy a cheap rivet gun and rivet the frame lock on.
Repair folding clip on navigator pram
Written by: Engineer for 24 yrs
03/04/2016 08:48 pm
I bought this product to repair the clip that holds the pram while folded.
The kit came with four self tapping screws to replace the riveted bracket that was factory fitted. The rivets where easily removed with the correct sized drill and pin punch. when installing the new bracket two of the screws supplied needed to be longer, the material the screws fastened into are punched holes and are recessed only 2-3mm on one side as such the self trappings screws wouldn't tighten the same as the the two screws on the opposite side. Simply replaced two of the self tappers with a slightly longer screw did the trick.